Новий Косарка-подрібнювач GHEDINI Flail cutter for excavators and backhoe loaders

Our hydraulic brush cutters are designed to be applied to excavators weighing between 7 and 25 tons and backhoe loaders.

Workings widths available :

1.300 mm

1.600 mm

1.900 mm

The bidirectional rotor and the lack of a roller allows the bush cutter to work in both directions.

Features STD bush cutter

The built-in-unit carpentry, like a normal bucket, allows it more resistance to possible accidental hits.

Possibility to regulate the connection plate.

Antishock and anticavitation valves, set to 160 bar, in order to protect the motor from possible damages due to a sudden change in pressure.

Drainage not needed : it works with only the in and out oil hoses.

The motor is bidirectional and in aluminium.

The rotor works at 3000 rpm for a better efficacy in the bush cutting.

The knives are "Y" shaped, with one more knife in the middle, allowing it to cut branches up to 12 cm diameter. Possibility of hammer rotor too.

Exclusively built with SKF bearings, rings nuts and lock washers.

Possibility both of direct or quick connection following customer's details.